-
R&D Units
The QMill-2 is designed for R&D laboratory needs. Starting PSD of raw material is 1mm approx. ...
-
Production Units
The ProMill-16 jet mill is designed for production needs. Typical batch sizes is between 20kg and...
-
R&D Units
The LaboMill-1 is the FPS answer to R&D lab needs when it comes to very initial stages of...
-
Pilot Units
The PilotMill-5 jet mill is designed for product developments needs and small production campaigns...
-
Production Units
The ProMill-8 jet mill is designed for production needs. The typical batch sizes is between 2kg and...
-
Pilot Units
The QMill-6 is required for final particle size between 15-20µm and 100µm (D50), Starting PSD of...
-
Mechanical Mills
PinMill is designed to reduce agglomerates of pharmaceutical, chemical and food products down to...
-
Production Units
The QMill-10 is required for final particle size between 15-20µm and 100µm (D50). Starting PSD of...
-
Pilot Units
The QMill-8 is required for final particle size between 15-20µm and 100µm (D50), Starting PSD of...
-
Production Units
The ProMill-12 jet mill is designed for production needs. Typical batch sizes is between 5kg and...
-
R&D Units
LaboMill-0 represents the right solution for preliminary feasibility micronization trials with...
-
Pilot Units
The PilotMill-2 jet mill is designed for product research and development's needs, where batches...
-
Pilot Units
The PilotMill-6 jet mill is designed for product developments needs and small production campaigns...
-
Micronization
Assistance and spare parts service have always been our strong point, because fps never stops!...
-
Pilot Units
The PilotMill-3 jet mill still more indicated for R&D activities, can start micronizing batch...
-
Pilot Units
The PilotMill-4 jet mill is designed for product developments needs, where batches from 5g to 60kg...
-
Production Units
The QMill-14 is required for final particle size between 15-20µm and 100µm (D50). Starting PSD of...
